At this point i have tryed to launch again TRAKTOR and after select ASIO!!! YEAAH!! It's worked!!Īt this point i thinks it's possibly it's windows came to use audio card and in some mode use at exclusive mode (on windows 7 圆4 on my old computer there's no same problems) and on windows 10 it's be only need to deselect to use ASIO. i have deselect as communication device also. i have deselect the BCD as Default device. If it does, make sure that windows is set to use the internal soundcard of the laptop as its default device and not the BCD3000 look here:ĭoes it show up windows control panel->audio? Otherwise i have apparently found a GOOD WORKAROUND. I have already contact the Behringer italia (or i need to contact someone diffear ?) but no response from here :(
We suggest to contact the developer of ASIO and ask for an update to the driver that is compatible with the recent update of Windows 10. Kindly post back with the updated issue for further assistance.
Click on ‘ Apply’ and click ‘ OK’ and run the file to install it. Click on the ‘ compatibility’ tab and check the box " Run this program in compatibility mode” and select previous Operating System from the drop down.Ĥ. Right-click on the setup file and click on " Properties".ģ. Download the latest Universal ASIO DriverĢ. Universal ASIO Driver in compatibility mode and check, if it works.įollow these steps to install the Universal ASIO Driverġ. If the issue still persists, I would suggest you to uninstall the Universal ASIO Driver from the Device Manager and reinstall the latest The method you use will depend on whether you have a single seat license or a Volume License Agreement. There are multiple ways to disable automatic updates of National Instruments software. Once this is done, restart the computer and check, if it works. National Instruments recommends that you install NI Update Service for easily installing software upgrades and patches. Press (Windows key + X) and click on “Device Manager”. In the Device Manager and check, if it works. I would suggest you to update the latest Universal ASIO Driver I would suggest you to try these following methods and check, if the issue still persists. This issue occurs due to the outdated and incompatible Universal ASIO Driver. We apologize for the inconvenience caused. I can understand, how frustrating it can be, when things don’t work as expected. I assumed I would just instal from DVD, then download and run whatever particular update would be required and then activate the plug in and be good to go.Thank you for posting your query in Microsoft Community. So, if someone has installed and runs B4II if they could shout out, that would be great.Īlso, if you did anything out of the ordinary to get it to run. There is an update available for the B4II which gives "leopard" support. I really just want to know, if someone is running B4II on snow leopard atm.because B4II has been discontinued by NI. I know thats not a very helpfull explanation.sorry. National Instruments recommends that you install NI Update Service for easily installing software upgrades and patches. I uninstalled B4II by running the uninstaller that came with it.then on a support page at Native Instruments, they listed all the files and their locations I had to manually remove.which I did. Then, I downloaded a installer update from Native Instruments, and ran it, and it failed with an error message, I cant recall.
"couldn't get it to install" -what do you mean? What happened exactly?